Aim: To try make the brass ball not fit into the ring and then make it fit again
Method:
1. Grab the bunsen burner and place it on top of the orange mat that is on the table
2. Plug it in the broen gas that is attached to the wall
3. Make sure that it is away from any other objects.
4. Lift the broen gas and twist but make sure the bottom of the bunsen burner hole is closed before it is lit
5. Ignite the bunsen burner at the top hole where the fire will come from
6. Make sure you get a cup of cold water
7. Hold the handle of the brass ball and the ring, Then place the ball first and as it is burning the heat energy starts to rise like get hotter.
8. Try see if you can fit the brass ball in the ring if it doesn't you might notice that the ball as expand or whatever you heated first.
So what we did was place the brass ball on top of the bunsen burner to see what happens and as you try it the ball will expand and will not be able to fit through the ring.
Make sure that you get a cup of cold water because the heat energy of the brass ball is hot and even if you get close to it, you might feel the heat.
And the movement of the particles in the solid you could nearly see starting to shake.
No comments:
Post a Comment
To support my learning I ask you to comment as follows:
1. Something positive - something you like about what I have shared.
2. Thoughtful - A sentence to let us know you actually read/watched or listened to what I had to say
3. Something thoughtful - how have you connected with my learning? Give me some ideas for next time or ask me a question.
Note: only a member of this blog may post a comment.